HackFonts.com

Basic font information

Font family: Kenteken Smits 2013

Font subfamily identification: Regular

Unique identifier: LeFlyFonts: Kenteken Smits 2013: 2013

Full font name: Kenteken Smits 2013

Version: Version 1.000

Postscript font name: KentekenSmitsTweeduizendDertien

Trademark notice: Please refer to the Copyright section for the font trademark attribution notices.

Manufacturer name: LeFly Fonts

Designer: LeFly

Description: Gebaseerd op een werktekening van J. B. Smits uit 1937

Dit werk is gelicenseerd onder een Creative Commons Naamsvermelding-GelijkDelen 3.0 Unported licentie

http://creativecommons.org/licenses/by-sa/3.0/deed.nl

Kenteken Smits 2013

2013

Read more

The 'Kenteken Smits' set of fonts represents the typography as used on vehicle license plates in The Netherlands between 1951 and 1979.

I was asked by the webmaster of nummerplaten.info to develop the original drawings from 1937 into a font. These originals were designed by mr J.B. Smits, director of the Amsterdam Institute for Applied Arts Education (Instituut voor Kunstnijverheidsonderwijs).

The name of the font set is in recognition of the original designer.

I ended up developing three versions.

'Kenteken Smits 1937' is a bare representation of the design as shown in a 1937 report on legibility of the design. It lacks C, O, I, Q and Y (these were not to be used on license plates). The character spacing is also as per the original design, i.e. suitable for producing license plates. This version is the most historically accurate of the three.
NOTE: Due to the 'incomplete' character set, 'Kenteken Smits 1937' will not be included in the publicly available download (just use 'Kenteken Smits 1951' instead, see below).
I'll give you this font if you make a voluntary donation through DaFont, though!

'Kenteken Smits 1951' is the font as it was finally used on actual license plates from 1951 onwards. Most notably the character '3' changed form. It also contains 'C' and 'O' which were added in later years to accomodate special issue plates (diplomatic and military). For good measure I completed the character set myself with an 'I', 'Q' and 'Y'. Spacing is still utilitarian. This is the version I recommend for 'typesetting' license plate mock-ups.

Finally, 'Kenteken Smits 2013' is a heavily expanded version. It contains a complete lower case set, accented characters, punctuation etc. Also the spacing has been adapted to accomodate other uses than 'plate setting'. For anything other than license plate mock-ups, I reccomend using this version.

These fonts are governed by the Creative Commons License: Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0) [http://creativecommons.org/licenses/by-sa/3.0/]

This means: free to distribute and free to use for typesetting any work (including commercial) without an additional license. Please keep this Read Me file with the original fonts when redistributing.
New fonts developed, derived or remixed from these designs can only be shared under the same license.

Feel free to contact me ([email protected]) for any questions regarding this font.
I also love to see how you use these fonts!

Enjoy,
Arthur